This step is critical.ħ.Ğnter or select the required RAID parameters. Use the up-down arrow buttons beside the list box to arrange disks in the correct sequence as they were connected to the RAID controller. Select ‘RAID Recovery’ and click ‘Scan.’ĥ.Ĝlick on RAID tab (RAID 0, RAID 5, or RAID 6) and move all RAID member disks to ‘Move hard drives up/down for disk order’ list box using arrow buttonsĦ. Select the files you want to recover and click ‘Next.’Ĥ. Open Disk Management tool and check all RAID disk are recognized and launch the softwareģ. Use SATA connectors or SATA to USB converter cablesĢ. The software is free to download.Īfter downloading Stellar Data Recovery Technician software, follow these steps to rebuild a virtual RAID for data recovery:ġ.Ĝonnect all RAID disks to a Windows PC. This is the safest and most affordable way to recover data from RAID drives with a dead RAID controller. This software rebuilds RAID 0, RAID 5, or RAID 6 array without RAID hardware or software controller-even if you don’t know or provide incorrect RAID parameters required to rebuild the virtual RAID. To rebuild a virtual RAID, you need a RAID data recovery solution such as Stellar Data Recovery Technician (Free Download link: ). If the RAID contains OS, make sure it is selected as primary boot device in the BIOS. Ideally, the RAID controller automatically imports the metadata from the disk and configures the RAID as it was-without any manual intervention.ĭo not change the sequence in BIOS. Remove the RAID drives from the RAID controller, if haven’t already and connect them in the same sequence as they were connected to the dead RAID controller. Skip to the next steps to rebuild virtual RAID without a RAID controller and recover your data safely. Plus, it won’t work if the RAID wasn’t healthy or had issues before the controller died. NOTE: This method may not be feasible for many. Follow this step at your own risk and only if you have cloned or created an image of your RAID disks. Otherwise, it could trash your RAID drives and make data recovery impossible. WARNING: This may or may not work! Try this if the RAID controller stores metadata on the disks. Get the same RAID controller card or motherboard installed with the same firmware (BIOS) version.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |